FeFET-based voltage-to-time converter reduces offset in 28-nm CMOS
A FeFET Voltage-to-Time Converter with Offset Trim by Programmed Multilevel State in 28-nm CMOS
Emerging Technologies
Summary
Voltage-to-time converters turn electrical voltage signals into time signals but often suffer from inaccuracies due to manufacturing differences, temperature, and power changes. The authors designed a converter that uses a special type of memory transistor, a FeFET, to store correction information and improve accuracy permanently. This design adjusts its own internal settings to reduce errors, resulting in more precise readings. Their chip operates efficiently in a modern 28-nanometer chip technology and shows promising speed and power performance in simulations.
What this means in practice
- •For analog circuit designers: Implement voltage-to-time converters with built-in permanent offset calibration using FeFETs to maintain accuracy across process and supply variations.
- •For low-power sensor engineers: Design time-domain signal processing blocks that achieve accurate voltage conversion with very low power consumption and fast operation for sensor interfaces.
Authors
Jeries Mattar, Hanaa Eqeiq, Stefan Dünkel, Halid Mulaosmanovic, Gunda Beernink, Sven Beyer, Nicolás Wainstein
Abstract
The offset and gain of voltage-to-time converters (VTCs) in time-domain circuits vary with process, supply, and temperature. This work presents a VTC whose nonvolatile input-referred offset trim is the programmed multilevel state of the ferroelectric field-effect transistor (FeFET) that converts the input. Fabricated in 28-nm CMOS, the 6.07-$μ$m$^2$ VTC consists of a current-starved inverter with the FeFET and a parallel NMOS leaker in its tail, a capacitor bank, and a following inverter. The programmed state shifts the transfer curve onto the input range, leaving the gain to the capacitor bank and the leaker bias. Measured at 10~MS/s, centered states weaken the second harmonic from $-$12.5~dB in the low-threshold state to $-$32.2~dB and lower the static integral nonlinearity (INL) at 5~bit from 2.42 to 0.92~LSB. Post-layout simulations indicate that the proposed VTC can operate at 500~MS/s, drawing 2.0~$μ$W from a 0.9-V supply, with nearly unchanged distortion and gain up to 700~MS/s. Across simulated process corners and $\pm$10\,\% supply variation, the input-referred offset is calibrated to within 10~mV and the gain to within 4\,\% of nominal by adjusting the programmed state and leaker bias.